|
Model
005-302 Fan Heater. 3,500 BTU @ 180 F 3 GPM Flow
Designed specifically for heating of a small
compartment similar to an Marine head compartment or small
stateroom. 3 ducting
and air outlet grill can be extended into those tight locations on a
boat.
Built in air vent and standard 3/4 water system connections.
Optional MPT or PEX solder fitting & two speed switch are
available. Complete
with heater, ducting, clamps and air grill.
Height :
4.125
Width : 6
Depth :
8
12 or 24V Models available
|
 |
Model 005-905FF Fan Heater 8,000 BTU @ 180 F 3 GPM flow
Dual 2.5 air outlets allow heating
of two adjacent small staterooms
or stateroom and marine
head compartment. The 2.5 flexible
ducting can be
extended into and past those small access openings.
The two air flow adjustable air grills allows heating balance at a
touch of the air flow louver. Built in air vent and standard 3/4
water system connections. Optional MPT or PEX solder fitting & two
speed switch are available. Complete with heater, ducting, clamps
and air grills. FF features allows multiple heater position
for ducting and hose routing.
Height : 5.75
Width : 7
Depth : 8.5 12 or 24V Models available
|
 |
Model 005-914FF fan Heater 8,000 BTU @
180F 3 GPM flow.
This four inch duct and air
grill equipped heater provides quiet
even heat in the
sleeping area and other areas.
In field air flow direction change is possible.
Remove 4 screws on the front and back reverse the motor and
air outlet and the front will be come the back with air flow in the
opposite direction. No need
for 180 degree duct routing to get the air pointed in the right
directions. Built in air vent and standard 3/4 water system
connections. Optional MPT or PEX solder fitting & two speed switch
are available. Complete with
heater, ducting, clamp and air grill.
Height :
5.75
Width
: 7
Depth : 8.5
12 or 24V Models available
|
 |
|
Model 005-919FF fan
heater 8,000 BTU @ 180F
3 GPM flow
This heater equipped
with three inch duct and air grill will fit into those location
where the four inch ducting cannot fit.
Similar equipped as the Models 005-905FF & 914FF for in-field
motor Air outlet air flow direction.
These FF Models can also be rotated
180 degrees so
the top becomes the bottom for water hose routing with out the need
for hose cross over.
Dual air vent fittings allow this feature. The Models 905FF,914FF &
919FF are all equipped with a five pass water coil for superior
water flow & heat output.
Height
: 5.75
Width :
7
Depth
: 8.5
12 or 24V Models available
|
 |
|
MSR Model 005-909II cabinet toe space
mounting fan heater.
Five pass water coil for 7,000 BTU rating. Black
anodized aluminum cutout cover air grill.
Low profile (3.75) allows installation in a cabinets toe
space or other low profile
location. Ideal heater
for galley space Installation for Warm Feet for the first mate for
morning coffee or meal
preparation. Heater can
also be mounted vertical in those narrow unused space on some
cabinets.
12 or 24V Models available
|
 |
|
MSR Model 005-941FF Single 4 air outlet fan
heater.
Five pass water coil for 16,500 BTU rating with
dual 12V .36A fans.
Complete with ducting, duct clamps & air
outlet
grill. Ideal fan
heater for large cabin heat utilizing
space saving single
duct & air outlet grill.
FF models allows hose routing and connection from
either side of the mounting compartment..
12 or 24V Models available
|
 |
|
MSR Model 005-942FF Dual 4
air outlet fan heater.
Five pass water coil for 16,500 BTU rating with
dual 12V .36A fans.
Complete with ducting, duct clamps & air
outlet
grills. Ideal
fan heater for large cabin heat utilizing dual outlets for even heat
circulation.
FF models allows hose routing and connection from
either side of the mounting compartment..
12 or 24V Models available
|
 |
|
MSR Model 005-942-C
Combination windshield defrost with four 2
outlets and single 4 outlet for helm station heat from one fan
heater. High capacity
squirrel cage 3 speed motor
for high air movement for windshield defrost and single quiet
low amperage fan for
helm station heat from one heater.
Heater is equipped with ducting, 2 & 3 speed
switch and air
Outlet grills.
12 or 24V Models available
|
 |
 |
All Heaters complete with
ducting & clamps & Air grills
Optional
equipment all fan heaters:
Two speed switch,
MPT or PEX solder fitting |
|
